Where To Find The Documentation Of Installation? Next, remove intake manifold runners carefully so you do not damage them when lifting out of motor mount bracket area once these are out you will be able to access coolant temperature sensor which should be located just above where runners meet motor mount bracket area on either side of motor mount bracket itself this will be at same height as thermostat housing so make sure you check both sides before replacing old part with new one to ensure accuracy when replacing part (as there may be slight differences between left/right side). To find this location on your Dodge Durango 3.6, locate and remove oil filter housing by unclipping clips that hold it in place, then disconnect wire harness that runs through it to access two bolts that hold intake manifold runners in place (these are located under oil filter housing). ![]() This can be easily accessed when removing oil filter housing and intake manifold runners as required for maintenance or repair work on your vehicles cooling system components. The location of the coolant temperature sensor in 2013 Dodge Durango 3.6 is on top of the intake manifold near where it meets with the cylinder head on either side of motor mount bracket. What is the Location Of Coolant Temperature Sensor in 2013 Dodge Durango 3.6? This helps maintain a safe operating temperature for your engine while improving its overall performance. ![]() As the resistance increases, more voltage is sent to the vehicle’s computer which adjusts fuel-air mixture and other engine settings accordingly. The sensor contains a thermistor that changes resistance as the temperature of the coolant changes. The sensor is usually located near the thermostat housing in an engine block or cylinder head. The coolant temperature sensor works by measuring the temperature of the coolant as it passes through its housing. How Does Coolant Temperature Sensor Works? The benefits of having a coolant temperature sensor include improved fuel efficiency, better engine performance and reduced emissions. By doing this, it helps maintain a safe operating temperature for the engine and prevents it from overheating. It monitors the temperature of the coolant and sends a signal to the vehicle’s computer to adjust the fuel-air mixture, ignition timing and other engine performance settings. The coolant temperature sensor is an important component of a vehicle’s engine cooling system. Monitor your engine’s performance after installation to ensure that your Durango is running smoothly and efficiently. Once you locate it, consult a guide to ensure correct installation. If youre looking for it in the 2013 Dodge Durango 3.6, you can expect to find it on the drivers side of the engine bay at the back, close to where your coolant hoses enter and exit the engine. The location of the sensor often varies across different models, but it can usually be found near the top of the engine, near the thermostat housing. The 2013 Dodge Durango 3.6 is equipped with a coolant temperature sensor that helps the engine to maintain ideal operating temperatures. ![]() 2013 Dodge Durango 3.6 Coolant Temperature Sensor Location The coolant temperature sensor for a 2013 Dodge Durango 3.6 is located on the passenger side of the engine near the thermostat.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |